Correct setup is essential to the operation of your sensor and meter. The
back of the D500 is shown in the drawings below. Locate the wiring code for your
individual sensor and connect accordingly. For a four-wire load cell is it
necessary to use a jumper from the +/- Excitation and +/-Sense (pictured).
The top picture shows the connections for the power. The power controls are
found on the left back of the meter. The blue plug (AC power, brown for DC
power) is the power connector, pin 4 is "digital input B", pin 5 is "digital
input A" and pin 6 is the "digital ground."
6-Pin Connection Port
Note: For 'INPUT' use STRN, 20.0
4-Pin Connection Port
Note: For 'INPUT' use RATIO, 0.20
