|
|
|
|
|
|
|
|
| Did You Know |
We offer instrument and accessories to go with your sensors
click here |
|
|
|
|
Alarms are used to indicate when a
specified value is reached. An alarms can be set to go off when the display is
reading a larger number then the preset value or a small number then the preset
value.
Wiring
Guide.. |
|
Note: Display will
automatically exit setup mode and return to run mode if a button is not pushed
within 30 seconds.
 |
| 1. |
Press both buttons at the
same time, ‘CAL’ will appear, press the bottom button until ‘Ky1’ or
‘Ky2’ appears. |
| 2. |
Select your desired key to
use. Once your choice is displayed on the screen press the top button. Scroll down this menu
until ‘AL1’ or ‘AL2’ appears (dependent upon the key choice).
Press the top
button. |
| 3. |
‘TyPE’ will appear,
press the top button again.
In this new menu use the bottom
button to scroll down the list of alarm types. To select your desired alarm
type, scroll through the menu until your choice is displayed on the meter then
press the top button.
‘TyPE’ will then appear on the meter. |
| 4. |
Press the bottom button and ‘rELY’ should
appear. Press the top button
and then use the bottom
button to view the menu options. Press the top button once you have made your
choice, ‘rELY’ will appear. Press the bottom button to continue through
the alarm menu. |
| 5. |
Press the top button on any of the menu
options that you wish to configure. Once you are done, scroll to ‘END’
and press the top button.
This will take you back to the main menu. |
|
|
|