|
|
A Password will prevent people from being able to change
settings in specific menus. If you set a pass-code it will be necessary to enter
that code whenever you are changing settings.
Do
NOT forget your pass-code! |
|
Note: Display will
automatically exit setup mode and return to run mode if a button is not pushed
within 30 seconds.
 |
| 1. |
Press both buttons at once, ‘CAL’ will
appear, press the bottom
button until ‘PASS’ appears on the display. Press the top button. |
| 2. |
‘FULL’ will then
appear. If you wish to enter a pass-code from 0001-9999 to control access to the
full menu press the top
button. If not press the bottom button. The other pass-code
options are listed below:
‘CAL’-controls access to the calibration
menu only
‘S P ’ –controls access to the setpoint values
‘PEAk’
– controls access to the Peak reset function |
| 3. |
Select your desired pass-code
function and access code by pressing the top button on the pass-code
function and using both keys to set the code. Press the top button until the display
returns to your pass-code function. Press the bottom button until ‘End’
appears. Press the top button
to return to the main menu. Your pass-code will now be needed in order to change
your protected settings. |
|
To remove a
pass-code, enter the null pass-code:
'0000' |
|
Do NOT forget
your pass-code! |
|
|